1. Home
  2. Question and Answer
  3. Houseplants
  4. Garden Articles
  5. Most Popular Plants
  6. Plant Nutrition

Only 1st station works


Question
Cable connections
Cable connections  

Outside panel
Outside panel  
We have HYDRO RAIN HR 6100 (probably 25 years old).  I have set it to run for 1 min/each for ALL 4 stations we have.  It worked fine until now.   

When I start it manually (to test), it waters station no. 1 for 1 min. and then the whole system stops. It does not move to station no. 2.  I tried tightening the cables for all stations but they all look secured and non rusted.   I have attached 2 images.

Any help you can provide would be greatly appreciated.  

Vilas Khare'

Answer
Hey Vilas, it could be the controller, or a problem with either the wire going to the valve, or the solenoid on the valve. First thing to do, is unscrew the screw on terminal #2 and take the wire off. Now try to run each station for 1 minute like before. If the display still does not move to station #2, then the controller is bad and you need a new controller. If it moves to station #2 on the display, then check the solenoid on valve #2 and replace it. If you need a new controller, Install a "Irri-trol" Rain dial controller. They are easy to program, and will last a long time. Good luck and have a great day.

Copyright © www.100flowers.win Botanic Garden All Rights Reserved