Question
i have a rainjet sys. n have had both pumps replaced. i've had da timer set up n have started it on manual mode n each time wen it gets to da 2nd phase it starts up for like 20 sec. den shuts down n reads "bad2". i had sum1 out here 2 days ago n dey replace da 2nd pump but still not workin properly HEEEELLLLPPP!! thanx!

Answer
Hi Tino

I'm assuming that when you says "pump" you are referring to valves, is OK?

If you replaced the valves and solenoids, the problem is on the wires from the controller to the valve. Check fir broken wires or shorted wires.
Regards
Guillermo