Question
Hello Mr.Reyes,

I am trying to install an Irritrol RFS1000 on a Toro TMC-212 controller. Are these compatible? Even with the install manual this wiring is confusing. The controller has a port for a toro sensor, but the irritrol has five wires coming from the receiver.2 red, 1 brown, 1 yellow and 1 white. Any advice on how to add this device to my controller?

Thanks,

Mike

Answer

toro   Hi Mike,

Remove the jumper on the sensor ports

Red wires go to the 24V ports on the Toro. Brown and white goes to the two sensor ports on the Toro. The yellow wire is not used.
Set the sensor SW on the Toro to EN and NC.

See picture

Regards
Guillermo