Question
I set only 1 program to run through 4 stations, it runs at the correct time through the 4 stations, but as soon as it finishes, it runs the entire program over again once more. I can not find another program which is set up for that time within the system. I have deleted the program and started over but doesn't help.

Answer
Hey Toni, I would suspect that you have more than one start time entered into the program. Check and make sure only the first start time is entered, and that the other start times are all set to off. For instance, lets say you have 4 zones and they all are set to run for 20 minutes (1 hour and 20 minutes total). You put the first start time in for 7:00am, but there is another start time set in at 7:30am. The controller will start the program at 7:00am and it will run until 8:20am. Now the controller will see another start time that was supposed to start at 7:30am and will run a second time. Just make sure you only have one start time entered. Good luck and have a great day.