Question
I have a Toro Gatekeeper 212 (older model).  How do you get a "Program X (A, B, or C)" to display when the switch is set to Run?  All configuration settings (ie., date/time, days to run, station times, etc have been set).  Without a program selection being recognized and displayed, the unit/sprinkling system won't sprinkle.  It may be the auto is turned off, I'm not sure. If so, how do you reactivate ir or turn it on?  It runs in manual mode just fine.

Answer
Hey Bill, I hope this helps. Anytime you put the switch to run, it is "not" going to dispay program A,B or C, because once the switch is set to run it is going to run all programs. The only time A,B,or C is going to show up, is when you are actually programming a particular program(A,B,C). Make sure you are programming all functions in whatever program(s) you are using. If it is not running automatically with the switch in run, and you have it programmed correctly, then you might have a faulty controller, and it needs to be replaced. Good luck and have a great day.